English Indonesian
[[!img install/inc/screenshots/install_etcher_in_mac.png link="no" alt=""]]
[[!img install/inc/screenshots/eject_etcher_dmg.png link="no" alt=""]]
[[!toggleable id="dd" text="""
Make sure that your USB stick is unplugged.
Execute the following command:
<p class="pre command">diskutil list</p>
It returns a list of the storage devices on the system. For example:
<p class="pre command-output">/dev/disk0
#: TYPE NAME SIZE IDENTIFIER
0: GUID_partition_scheme *500.1 GB disk0
1: EFI 209.7 MB disk0s1
2: Apple_HFS MacDrive 250.0 GB disk0s2
3: EFI 134.1 GB disk0s3
4: Microsoft Basic Data BOOTCAMP 115.5 GB disk0s4</p>
Plug your USB stick in the computer.
Execute again the same command:
Your USB stick appears as a new device in the list. Check
that its size corresponds to the size of your USB stick.
<p class="pre command-output">/dev/disk0
#: TYPE NAME SIZE IDENTIFIER
0: GUID_partition_scheme &lowast;500.1 GB disk0
1: EFI 209.7 MB disk0s1
2: Apple_HFS MacDrive 250.0 GB disk0s2
3: EFI 134.1 GB disk0s3
4: Microsoft Basic Data BOOTCAMP 115.5 GB disk0s4
/dev/disk1
#: TYPE NAME SIZE IDENTIFIER
0: FDisk_partition_scheme *8.0 GB disk1
1: Apple_HFS Untitled 1 8.0 GB disk1s1</p>
Take note of the *device name* of your USB stick. In this example, the USB stick is 8.0 GB and its device name is <span class="code">/dev/disk1</span>. Yours might be different.
<div class="caution">
<p>If you are unsure about the device name, you should stop proceeding or
<strong>you risk overwriting any hard disk on the system</strong>.</p>
</div>
Execute the following commands to copy the USB image that you downloaded earlier to the USB stick.
Replace:
<span class="command-placeholder">tails.img</span> with the path to the USB image
<div class="tip">
<p>If you are unsure about the path to the USB image, you can insert the
correct path by dragging and dropping the icon of the USB image from
<span class="application">Finder</span> onto <span class="application">
Terminal</span>.</p>
</div>
<span class="command-placeholder">device</span> with the device name found in step 6
<div class="tip">
<p>You can try adding <span class="code">r</span> before <span class="code">disk</span> to make the installation faster.</p>
</div>